Fed up of burning holes in my trousers and melting my waterproofs Anyone have one, or know where I could get one from

_________________
Wear the fox hat

Was hoping Alan of aph would think about making them.

Maybe if somebody asked him

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

maybe if enough somebodies asked him nicely

_________________
Feros Ferio

The right price and I'd be in, mines 80% (flat spot from trying to ride off with a disclock on - 170 miles on the clock ) and it buggs me

_________________
Today my pet mouse Elvis died ..................He was caught in a trap
There are two types of people in this world, those that can extrapolate

_________________
Wear the fox hat

I would say give it a try yourself!

_________________
The sound of a V-twin engine braking is music to my ears!!

Mine would look as dimpled as a fat lasses thigh!

...but somewhat smaller.

_________________
'98 M2 Razorback, it's a keeper.

Certain mine would look worse than the one I'm looking to replace, more like a relief map of Wales

_________________
Today my pet mouse Elvis died ..................He was caught in a trap
There are two types of people in this world, those that can extrapolate

Go by a muffler shop and have them bent a piece that is the correct diameter and cut a shield out.
It can't be that difficult!

_________________
The sound of a V-twin engine braking is music to my ears!!

You can buy stainless bends, of different diameters, on line.

_________________
If your dreams don't scare you, they are not big enough.

They`re twin skined , a single skin would just heat up too much.

Didn't know that!

The one i have is single skined (it was a burn victim ,so that could explaine it)

_________________
The sound of a V-twin engine braking is music to my ears!!

http://www.ebay.co.uk/itm/Buell-S1-earl ... Sw46BZrvC9 Shows the reverse. Might be some insulation held with metal tape. Can`t be arsed to take mine off to look.