ok, does anyone know what thread the XB mirrors are ... ? I want some smaller ones but don't know what will fit and what don't.

On my M2 on had bar end ones, they were cheepy ones that fit the 7/8" renthals I had and were great, the Bars on my STT are Pro Taper Evo's and the same mirrors wound right up still don't fit, which means I will be needing some more conventional style ones. This leads me on to what will fit and what wont. Been looking on a variety of sites and rizoma do some lovely ones but at £80 (-VAT ) they are a bit pricey when I will need two of them!

Apparently some KTM ones fit and look good ... Tubbs do you have anything to fit oversized bars ... ?

Suggestions ... ?


Maz, don't look like that!

_________________
"With square conduct, level steps, and upright intentions ..”

Go to you local hardwear (B+Q etc) builders merchants etc,etc and get a rawlbolt that'll fit up yer bars They come in all sorts of sizes. Use that to fit your bar ends on with I always use them instead of the poxy fittings that come with bar end mirrors
If you get one that uses a M8 thread, I've got some long, button head, stainless set screws that'll look a bit posher than the zinc plated bolt they'll come with

_________________
If your dreams don't scare you, they are not big enough.

i can make you somthing im sure burger at quay will cover it

_________________
Do you want it right or right now ?

Adam - that's a good idea, never thought of that!

Tubbs - Sold, its amazing what you will do for food, see you tomorrow eve sometime!

_________________
"With square conduct, level steps, and upright intentions ..”

are you going to meet anywhere

_________________
Do you want it right or right now ?

No idea, I think .. near the band stand is the usual spot ... been so long since I have been to it ...

_________________
"With square conduct, level steps, and upright intentions ..”