I need a Mikuni flat slide ultrasonically cleaned and checked out. Have recently been quoted 8/10 weeks Does anyone have any recommendations of companies used?

_________________
Dusty 001

Buy a ultrasound bath and DIY?

Out of interest what was the cost of a professional job?

8-10 weeks, they’re pulling you leg. It takes less than an hour😂

_________________
If your dreams don't scare you, they are not big enough.

My apologies, I’ve no constructive advice as I’ve never had it done Some years ago I bought one of those very cheap ultrasound jewellry cleaners from Aldi. It works well on small stuff like jets and switchgear, but it’s too small for a carb.

_________________
If your dreams don't scare you, they are not big enough.

Check out Allendale ultrasonics......I have the 6L Cavitek professional and it works a treat

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

I picked up a secondhand 3 ltr one that is identical to the Allendale , and it makes an amazing job of cleaning carbs , I bought the Carb cleaning solution which you dilute 10-1 from Allendale for mine.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

_________________
Wear the fox hat

and use Distilled or deionised water

_________________
Buell Ulysses XB12X 06/08

If it's just Dusty, a quick brush would do..........

_________________
2017 KTM 690 Duke
2001 M2
2019 Street Triple RS
2004 Monster S4R
Wilier La Triestina

Got one here if you`re passing by.