Got the Uly out after the lockdown - great to be riding again although it still farts around a bit at low revs, but fine at higher revs. Fan runs when hot even though I'm not thrashing it.
Thought I'd learn a bit more about ECMSpy etc so I've logged (ECMDroid & Buelltooth) a recent ride (file attached in case a nice person wants to have a peek!) and managed to get MegaLogViewer to work to see the parameters.
I'm sure the fuel map is the OE one (laboriously compared front and rear with a factory file for BUEZD).
So - questions -
1. AFV is ALWAYS 100. Never less, never more.
Is there a setting that fixes it to a certain setting (100) that I can undo?
I thought it should vary as required (and maybe keep the engine cooler).
2. Is it normal for the fan to run continuously (for 15-20 minutes (or more) whilst riding on A roads, 50-70MPH)?
On temp is set to 220C, off temp is 180C - highest temp logged was 240C!
Seems hot to me although factory ultimate cutoff is 325C (when engine shuts down).
After that ride, I've fitted the additional earth wiring (headstock, coil and starter lead from centre tie bar, all direct to battery -ve) per this thread https://www.buellxb.com/forum/showthrea ... hy-and-How
Done TPS reset but still have to change spark plugs (front has rust on it!) - ordered NGK Iridiums.
All help greatly appreciated (calling Gunter and Pash!)