Hi,can anybody give spanner sizes and allen key sizes for xb please as need them to do oil pump drive gear
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| spannering https://ukbeg.com/forum/viewtopic.php?f=10&t=16388 |
Page 1 of 1 |
| Author: | sinfield4 [ 16 Feb 2013 18:31 ] |
| Post subject: | spannering |
Hi,can anybody give spanner sizes and allen key sizes for xb please as need them to do oil pump drive gear
|
|
| Author: | kevmean [ 16 Feb 2013 18:37 ] |
| Post subject: | Re: spannering |
Don't forget you need to remove the pressure off the cams by removing the rockers first before you remove the cam cover ....and also pay very very close attention to making sure you tighten them back down v.....e...........r...........y s.....l........o........w..........l.......y to allow the hydraulic tappets to bleed back down when you reassemble, failure to do this could result in very expensive damage especially if you turn the engine over too soon  Make sure you read the manual for positioning engine, timing the cams if they fall out etc before you start
|
|
| Author: | Maz [ 16 Feb 2013 20:15 ] |
| Post subject: | Re: spannering |
Why did you post this in the 'For Sale' section ? .....I'll educate you on everything when you collect your parts 
|
|
| Author: | sinfield4 [ 16 Feb 2013 22:27 ] |
| Post subject: | Re: spannering |
Thank u maz,will be picking them up monday |
|
| Author: | cooter [ 18 Feb 2013 11:33 ] |
| Post subject: | Re: spannering |
Maz wrote: Why did you post this in the 'For Sale' section ? Should you really be spannering? |
|
| Author: | muzza [ 19 Feb 2013 23:17 ] |
| Post subject: | Re: spannering |
cooter wrote: Maz wrote: Why did you post this in the 'For Sale' section ? Should you really be spannering? the bike will be for sale soon i guess 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|