I reckon you need a new keyboard as well
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| X1 Lightning part https://ukbeg.com/forum/viewtopic.php?f=11&t=12481 |
Page 1 of 1 |
| Author: | petester [ 04 Oct 2011 19:57 ] |
| Post subject: | X1 Lightning part |
Runnin a red racin stripe 2000X1 in Inverness with a tail tidy panel under the seat but want2 lean up the back end an get it off. Lookin4 the standard "trunk" its called in the manual2 fill in the gap where the highland weather will pish all over my electrics. Anyone got 1 lyin about? |
|
| Author: | Nutah [ 23 Oct 2011 11:16 ] |
| Post subject: | Re: X1 Lightning part |
http://www.ebay.co.uk/itm/BUELL-X1-LIGH ... 415e882aee |
|
| Author: | Ash [ 23 Oct 2011 17:33 ] |
| Post subject: | Re: X1 Lightning part |
I reckon you need a new keyboard as well
|
|
| Author: | petester [ 07 Nov 2011 20:45 ] |
| Post subject: | Re: X1 Lightning part |
6 yrs in 2 para got big fingers! |
|
| Author: | petester [ 07 Nov 2011 21:01 ] |
| Post subject: | Re: X1 Lightning part |
Cheers Nutah! Didn't like the look of it so gonna fab1 up from a wide aluminium mudguard instead! |
|
| Author: | Adam [ 07 Nov 2011 21:19 ] |
| Post subject: | Re: X1 Lightning part |
petester wrote: Cheers Nutah! Didn't like the look of it so gonna fab1 up from a wide aluminium mudguard instead! That's the spirit  I think there's a photo of one made from an old road sign, somewhere on this site. I used some very thick plastic sheet shaped with a heat gun. You can relocate the seat lock on the other side of the bike. Seal it all up with silicone esp around the back of the rear light etc.
|
|
| Author: | Nutah [ 08 Nov 2011 03:14 ] |
| Post subject: | Re: X1 Lightning part |
the old road sign was mine  made an aliminium one to replace it just made a template out of cardboard (Blue Peter style) then cut the ali to fit cant link the pic as at work 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|