Runnin a red racin stripe 2000X1 in Inverness with a tail tidy panel under the seat but want2 lean up the back end an get it off. Lookin4 the standard "trunk" its called in the manual2 fill in the gap where the highland weather will pish all over my electrics. Anyone got 1 lyin about?

_________________
Feros Ferio

I reckon you need a new keyboard as well

_________________
"With square conduct, level steps, and upright intentions ..”

6 yrs in 2 para got big fingers!

Cheers Nutah! Didn't like the look of it so gonna fab1 up from a wide aluminium mudguard instead!

That's the spirit I think there's a photo of one made from an old road sign, somewhere on this site. I used some very thick plastic sheet shaped with a heat gun. You can relocate the seat lock on the other side of the bike. Seal it all up with silicone esp around the back of the rear light etc.

_________________
If your dreams don't scare you, they are not big enough.

the old road sign was mine
made an aliminium one to replace it
just made a template out of cardboard (Blue Peter style)
then cut the ali to fit

cant link the pic as at work

_________________
Feros Ferio