Stupidly, when I fitted my F/S tensioner, I didn't relieve the front plastic pulley cover. The belt rubbed, picked up bits of plastic, which then damaged the coating on the jockey wheel - all in the space of about 60 miles!
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| XB12R Belt pulley/jockey? wheel https://ukbeg.com/forum/viewtopic.php?f=11&t=540 |
Page 1 of 1 |
| Author: | Lordfenwick [ 22 May 2009 11:01 ] |
| Post subject: | XB12R Belt pulley/jockey? wheel |
Anyone got one going spare? Cheers richardfensome@mac.com |
|
| Author: | pash [ 22 May 2009 16:19 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
What is wrong with yours? Bearings gone? Stand by for a How To... |
|
| Author: | Lordfenwick [ 26 May 2009 11:32 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
Stupidly, when I fitted my F/S tensioner, I didn't relieve the front plastic pulley cover. The belt rubbed, picked up bits of plastic, which then damaged the coating on the jockey wheel - all in the space of about 60 miles!
|
|
| Author: | Lordfenwick [ 26 May 2009 11:36 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
I fitted it before you posted your excellent "how to........, btw. 
|
|
| Author: | pash [ 26 May 2009 11:54 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
How bad is the surface? Surely it can be recovered... |
|
| Author: | Maz [ 26 May 2009 12:13 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
In stock 95.91 incl. vat.......where abouts are you located ? |
|
| Author: | Bonzo [ 26 May 2009 12:27 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
Maz wrote: In stock 95.91 incl. vat.......where abouts are you located ? On the floor, gibbering 
|
|
| Author: | Lordfenwick [ 26 May 2009 12:50 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
Basingstoke......a place of much gibbering......bit too far, Maz, but thanks anyway. Surprisingly, it's scored quite badly - sufficient to continue marking the belt now everything has been cleaned off. I did consider skimming it on a lathe but it's coated for a reason, I guess, and it would mean removing the anodized coating. It may be going a bit over the top to change it, but the last thing I want right now is the cost of a replacement belt |
|
| Author: | pash [ 26 May 2009 16:52 ] |
| Post subject: | Re: XB12R Belt pulley/jockey? wheel |
http://cgi.ebay.co.uk/BUELL-FIREBOLT-XB ... 7C294%3A50 |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|