| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Output shaft nipple xb https://ukbeg.com/forum/viewtopic.php?f=11&t=7624 |
Page 1 of 1 |
| Author: | b16_4ndy [ 16 Jul 2010 22:03 ] |
| Post subject: | Output shaft nipple xb |
Anyone know where how to get one now that maz aint posting, was considering posting liberal amounts of jaffa cakes to him with payment and sae, want my old girl to last bit longer! |
|
| Author: | andrewandcarly [ 16 Jul 2010 22:16 ] |
| Post subject: | Re: Output shaft nipple xb |
I know a place I could get one from... |
|
| Author: | morini01 [ 17 Jul 2010 07:50 ] |
| Post subject: | Re: Output shaft nipple xb |
Any engineers merchants will have the grease nipples.pennies! The plate would be a simple matter to have turned up by anyone having access to a lathe and accurate measuring equipment. The only other issue then is to match the thread form of the nipple but again the friendly machinist comes to the rescue 'cos it can be done in the lathe or by hand with a tap. I may well make one myself but an undecided as yet. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|