UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
M2 Cyclone dip stick https://ukbeg.com/forum/viewtopic.php?f=7&t=11827 |
Page 1 of 1 |
Author: | geoff_52 [ 30 Jul 2011 23:20 ] |
Post subject: | M2 Cyclone dip stick |
On my Cyclone dip stick there are two marks presumably one for low and one for high oil level, If I have the oil nearer the high level mark the oil filler cap blows off after a minute or two while the engine is running! so I only have the oil showing on the bottom of the stick now in case this happens when i'm riding it, I did notice when I changed the oil the book said 1.9 litres was needed, but that didn't even touch the bottom of the dip stick thats why I put a little more in hense filler cap popping of. do you think I have the wrong dip stick or dont those two marks mean anything. any info please ![]() |
Author: | Maz [ 30 Jul 2011 23:34 ] |
Post subject: | Re: M2 Cyclone dip stick |
They all do that sir ![]() ![]() ![]() Oil change requires 2.5 US quarts, which is aprox 2.5L........oil should be drained when hot and immediately after shutting off the motor or wet sumping will occur. 2L of oil should be put into the tank and then run the engine whilst watching for circulation.......top up until level is between the marks on the stick. |
Author: | geoff_52 [ 01 Aug 2011 01:03 ] |
Post subject: | Re: M2 Cyclone dip stick |
Maz wrote: They all do that sir ![]() ![]() ![]() Oil change requires 2.5 US quarts, which is aprox 2.5L........oil should be drained when hot and immediately after shutting off the motor or wet sumping will occur. 2L of oil should be put into the tank and then run the engine whilst watching for circulation.......top up until level is between the marks on the stick. Thanks Maz ![]() ![]() ![]() |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |