| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| 2 QUESTIONS FOR MAZ https://ukbeg.com/forum/viewtopic.php?f=7&t=13051 |
Page 1 of 1 |
| Author: | Algarve Nick [ 06 Dec 2011 13:56 ] |
| Post subject: | 2 QUESTIONS FOR MAZ |
Getting my fork seal done in Portimao at the Honda shop next week. Regarding the heavy oil how much should go in the fork leg? And what is the torque setting when putting the wheel back on? |
|
| Author: | pash [ 06 Dec 2011 16:13 ] |
| Post subject: | Re: 2 QUESTIONS FOR MAZ |
There is a Uly manual above in this forum, however be careful as 06, 07 and 08 model years have different oil levels. Change between 06 and 07 was brought about by a change in spring, the 08 (09 and 10 models I assume are the same level) had bigger fork legs. You normally measure the depth from the top of the leg fully compressed with no spring after pumping it a dozen times to ensure the air is forced out. First thing to do is identify which model year you have. |
|
| Author: | Maz [ 06 Dec 2011 16:27 ] |
| Post subject: | Re: 2 QUESTIONS FOR MAZ |
Oil level is 113mm from the top of the tube......as Pash sez, fork must be fully compressed, no spring and damper bled properly.......you watched me do this  Front axle - 40ftlb Pinch bolts - 20ftlb Caliper bolts 35ftlb Bottom yoke pinch bolts - 20ftlb Top yoke pinch bolts - 24ftlb |
|
| Author: | pash [ 06 Dec 2011 16:38 ] |
| Post subject: | Re: 2 QUESTIONS FOR MAZ |
Maz wrote: Oil level is 113mm from the top of the tube...... Ah 2006... |
|
| Author: | Maz [ 06 Dec 2011 17:02 ] |
| Post subject: | Re: 2 QUESTIONS FOR MAZ |
Correct 
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|