| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| MAKE THE TWAT https://ukbeg.com/forum/viewtopic.php?f=7&t=14226 |
Page 1 of 1 |
| Author: | WILLYBUELL [ 22 Apr 2012 21:29 ] | ||
| Post subject: | MAKE THE TWAT | ||
had sum spare time again sooooooo nocked this up to draw bearings in xb wheels & tapers in the headstocks ,popped sum new rear bearings in me spare wheel as a test BOB ON YOUTH
|
|||
| Author: | MadRat [ 23 Apr 2012 09:50 ] |
| Post subject: | Re: MAKE THE TWAT |
|
|
| Author: | Adam [ 23 Apr 2012 11:32 ] |
| Post subject: | Re: MAKE THE TWAT |
I knocked up a set of those from ally bar. I put a little relief to ensure clearance around the radius of the inner race - just to make sure there was absolutely no pre load on the middle of the bearing. Makes life easier than twatting them in with a hammer  
|
|
| Author: | WILLYBUELL [ 23 Apr 2012 12:16 ] |
| Post subject: | Re: MAKE THE TWAT |
my inner faces have relief as well ,i had sum personal relief yesterday as well   very nice
|
|
| Author: | Adam [ 23 Apr 2012 13:20 ] |
| Post subject: | Re: MAKE THE TWAT |
|
|
|
| Author: | chris(madrid) [ 23 Apr 2012 15:01 ] |
| Post subject: | Re: MAKE THE TWAT |
Adam wrote: Makes life easier than twatting them in with a hammer Not as satisfying though!
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|