UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
XB9 dyno https://ukbeg.com/forum/viewtopic.php?f=7&t=14571 |
Page 1 of 1 |
Author: | pash [ 31 May 2012 11:06 ] |
Post subject: | Re: XB9 dyno |
How far in the pipe was the dyno sensor? Remember it is reading from two pipes and is not as hot as your slave sensor already fitted. My Firebolt has a Ti Force and does not have a dip. http://ukbeg.com/archive/modules.php?na ... ic&t=32691 |
Author: | natural [ 31 May 2012 11:57 ] |
Post subject: | Re: XB9 dyno |
Hi Pash, thanks for the answer. The exhaust is a Force Streetfighter, no a Ti-Force. The one I have is like this but jet hot coated black instead of inox. The sensor is about 8 inches inside the pipe, may be not inside enough. Anyway, the readings are completely different, 10:1 vs > 18:1. Definetely I think I should ask the dyno operator to install his sensor in the bung instead of mine, and configure the ECM to ignore it. I will be going on monday with some other Buellers. Thanks! |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |