do the spindals press out of buell cams ,von n me have a need to know if so
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| CAM QUESTION https://ukbeg.com/forum/viewtopic.php?f=7&t=15159 |
Page 1 of 1 |
| Author: | WILLYBUELL [ 01 Aug 2012 22:56 ] |
| Post subject: | CAM QUESTION |
do the spindals press out of buell cams ,von n me have a need to know if so
|
|
| Author: | Maz [ 02 Aug 2012 00:19 ] |
| Post subject: | Re: CAM QUESTION |
No......only the pinion on rear inlet cam (tuber) or front inlet (XB) |
|
| Author: | WILLYBUELL [ 02 Aug 2012 07:50 ] |
| Post subject: | Re: CAM QUESTION |
cheers maz ,brian will be very interested that the other three cams are ground as a complete item  ,
|
|
| Author: | rik [ 02 Aug 2012 09:14 ] |
| Post subject: | Re: CAM QUESTION |
Willy, Maz means that all four cams are ground, not pressed, and the only removable part on any of them is the oil-pump pinion... |
|
| Author: | pash [ 02 Aug 2012 09:23 ] |
| Post subject: | Re: CAM QUESTION |
Drive gear which is connected to the pinion gear rather than anything to do with the oil pump. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|