| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| servo motor https://ukbeg.com/forum/viewtopic.php?f=7&t=1619 |
Page 1 of 1 |
| Author: | aks12rrrrr [ 14 Jul 2009 21:00 ] |
| Post subject: | servo motor |
am hoping to source a can in the next few weeks but was just wondering if i would need the exhaust valve emulator http://www.trojan-horse.co.uk/prods/97.html as it says - wont need it if using a race ecm but what about a stock ecm with a race ecm map? dont know if there is a physical difference between the 2... apologies is this has been covered 
|
|
| Author: | mike [ 14 Jul 2009 21:15 ] |
| Post subject: | Re: servo motor |
 http://www.ukbeg.com/archive/modules.ph ... t=emulator |
|
| Author: | sportster_mann [ 14 Jul 2009 22:30 ] |
| Post subject: | Re: servo motor |
IIRC you have 3 options to not getting an error regarding the exhaust valve. 1.. remove the servo and fit the emulator 2.. leave the servo in place but leave the cable disconnected from the exhaust 3.. get somebody to disable it in the ECM with ECMSpy |
|
| Author: | aks12rrrrr [ 15 Jul 2009 00:13 ] |
| Post subject: | Re: servo motor |
hmm will go with option 1 if i can suss a cheap one on evil-bay 
|
|
| Author: | Maz [ 15 Jul 2009 00:39 ] |
| Post subject: | Re: servo motor |
Nip over to the shop and I'll switch it off with EcmSpy......only takes a few seconds 
|
|
| Author: | pash [ 15 Jul 2009 02:52 ] |
| Post subject: | Re: servo motor |
viewtopic.php?f=17&t=1375 |
|
| Author: | Lucky [ 15 Jul 2009 13:09 ] |
| Post subject: | Re: servo motor |
aks12rrrrr wrote: am hoping to source a can in the next few weeks but was just wondering if i would need the exhaust valve emulator http://www.trojan-horse.co.uk/prods/97.html as it says - wont need it if using a race ecm but what about a stock ecm with a race ecm map? dont know if there is a physical difference between the 2... apologies is this has been covered Why do you need the emulator? If the cable is disconnected it does nothing anyway? |
|
| Author: | pash [ 15 Jul 2009 14:25 ] |
| Post subject: | Re: servo motor |
Lucky wrote: aks12rrrrr wrote: am hoping to source a can in the next few weeks but was just wondering if i would need the exhaust valve emulator http://www.trojan-horse.co.uk/prods/97.html as it says - wont need it if using a race ecm but what about a stock ecm with a race ecm map? dont know if there is a physical difference between the 2... apologies is this has been covered Why do you need the emulator? If the cable is disconnected it does nothing anyway? Except set the Check Engine Light. The emulation is there to make the ECM think it is working... |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|