As I have just removed a 1mm piece of wire, that had gone into the rear tyre about 12mm deep...

About 9cm from the centre of the tyre.

I have marked the position and tested with soap and no bubbles emerged.....

Looked like it went straight in but then could be a bit on the slant.....



Cheers.....

http://www.ehow.com/list_7561789_specif ... tires.html
Hope it helps

_________________
I hate being strapped for cash....but it pays the bills

I don't think you'll find the info for the full carcass depth though which is what you really want to know .....................if it didn't go right through and was only wire size i'd say you were still good to go.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Yep that's what I meant.



I will check on it every so often...

Thanks Mr Finners an Mr Kev...