UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
Unexpected delivery! https://ukbeg.com/forum/viewtopic.php?f=7&t=18283 |
Page 1 of 1 |
Author: | Ash [ 09 Feb 2014 14:03 ] |
Post subject: | Re: Unexpected delivery! |
Thats very nice, looks complex to fit! |
Author: | richie [ 09 Feb 2014 14:10 ] |
Post subject: | Re: Unexpected delivery! |
Not if you sit on it |
Author: | Mickrick [ 09 Feb 2014 18:20 ] | |||
Post subject: | Re: Unexpected delivery! | |||
10 minutes. Job done.
|
Author: | Maz [ 09 Feb 2014 18:24 ] |
Post subject: | Re: Unexpected delivery! |
......where's your trans lube plug ? |
Author: | Mickrick [ 09 Feb 2014 18:34 ] |
Post subject: | Re: Unexpected delivery! |
Hi Maz, I didn´t realise the mod was for tubers until recently! It´s on my jobs to do list. I´m assuming you mean the nipple mod? |
Author: | Maz [ 09 Feb 2014 18:49 ] |
Post subject: | Re: Unexpected delivery! |
Yep......and why is your +ve battery lead routed wrong.......and is that a standard rear brake line |
Author: | Mickrick [ 09 Feb 2014 18:56 ] |
Post subject: | Re: Unexpected delivery! |
The + battery cable was routed over the top of the battery, and was chaffing on the frame. I haven´t got to brakes yet. More on my jobs to do list. I will replace the brake lines eventually, and strip and rebuild the callipers. The bike was a total shitter when I got it, so I´m slowly working my way through it. I need to focus on getting it to run now. |
Author: | t965m [ 10 Feb 2014 15:12 ] |
Post subject: | Re: Unexpected delivery! |
Total shitter? It looks pretty good to me - it'll be good to see it when it's finished |
Author: | Mickrick [ 10 Feb 2014 18:55 ] |
Post subject: | Re: Unexpected delivery! |
Thanks a lot. I think it´s starting to look better now, but it really was rough. I should have a short tail arriving any day now, so she´s starting to get the look I´m after. But I need to get some miles on the old war horse now, and curb the spending a bit. The plan is to do a winter strip down, in a year or two, once I have built a workshop at home, and do the powder coating and plating etc. and a bit of engine work. But as I mentioned earlier, brakes and a couple of little jobs next. Eventually ..... |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |