UK Buell Enthusiasts Group
https://ukbeg.com/forum/

Belt pulley bearing size or number
https://ukbeg.com/forum/viewtopic.php?f=7&t=21211		 Page 1 of 1
Author:  37skippy [ 27 Feb 2016 11:15 ]
Post subject:  Belt pulley bearing size or number
Hiya peeps,

I replaced the free spirits tensioner last weekend but found the bearings in the pulley are shot, does anyone have the size or correct number or even a link to them so I can get a new one? is there 1 or 2 bearings in there,

cheers folks

Julian :yup:
Author:  jeznewsome [ 27 Feb 2016 11:19 ]
Post subject:  Re: Belt pulley bearing size or number
How to section is really useful.....

http://www.ukbeg.com/forum/viewtopic.php?f=17&t=819
Author:  37skippy [ 27 Feb 2016 11:26 ]
Post subject:  Re: Belt pulley bearing size or number
jeznewsome wrote:
How to section is really useful.....

http://www.ukbeg.com/forum/viewtopic.php?f=17&t=819



Doh, I did have a look through but was in the wrong place :headbang:


Cheers jeznewsome :yup:
Author:  pash [ 27 Feb 2016 14:29 ]
Post subject:  Re: Belt pulley bearing size or number
Mint
Author:  37skippy [ 27 Feb 2016 16:26 ]
Post subject:  Re: Belt pulley bearing size or number
pash wrote:
Mint


Is that polo, extra strong or soft? :rotfl:
Author:  barney [ 27 Feb 2016 21:29 ]
Post subject:  Re: Belt pulley bearing size or number
37skippy wrote:
pash wrote:
Mint


Is that polo, extra strong or soft? :rotfl:

sauce :roll: :ner:
Author:  gusm2 [ 27 Feb 2016 22:12 ]
Post subject:  Re: Belt pulley bearing size or number
Tut tut, tech remember........ you'll have the headmaster :maz: after you in a minute ;)



Oops not tech :oooops:
Author:  Jill Brown [ 27 Feb 2016 22:21 ]
Post subject:  Re: Belt pulley bearing size or number
I am banned from tech, so cannot comment.... lOl

Oops....just did..!!! :ner:

Haha just realised it must have been moved...now in Buell chat...lol
Author:  37skippy [ 28 Feb 2016 07:38 ]
Post subject:  Re: Belt pulley bearing size or number
barney wrote:
37skippy wrote:
pash wrote:
Mint


Is that polo, extra strong or soft? :rotfl:

sauce :roll: :ner:




Hmmmmmmmmmmmm ok you got me there :clap:
Author:  Finmows [ 28 Feb 2016 10:59 ]
Post subject:  Re: Belt pulley bearing size or number
37Skippy wrote:
Doh, I did have a look through but was in the wrong place :headbang:

Lots of folk say that bout Birmingham ;) lOl
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/