UK Buell Enthusiasts Group
https://ukbeg.com/forum/

Frame covers
https://ukbeg.com/forum/viewtopic.php?f=7&t=23742		 Page 1 of 1
Author:  barney66 [ 25 Mar 2019 22:32 ]
Post subject:  Frame covers
Hi, has anybody fitted the carbon kevlar frame covers that I have seen on ebay ? if so what is the fit like ?, I like the look of them and I guess they would give a little protection against scratches.

Thanks in advance
barney
Author:  Nutah [ 26 Mar 2019 09:03 ]
Post subject:  Re: Frame covers
they are normally there to hide crash damage , when the bikes been dropped the impact of being dropped would put a dent in the frame/fuel tank (rather than just scratches ) & then dependant on the "engineers inspection"
from insurance they can write them off , through ignorance ... :sad1:
if i remember they're a stick on item , can't be sure if it's just mastic holding them on
you could just stick on some carbon look vinyl if you only want the look , would be cheaper .
Author:  barney66 [ 27 Mar 2019 05:57 ]
Post subject:  Re: Frame covers
Thanks for the reply Nutah,
Not keen on Vinyl, we have a lot of graphics done on our exhibition units at work, soon go to look tatty and wouldn't wear very well where your knees go.
If they are a good fit I would have the carbon fibre ones and stick them on

Thanks for the reply
Author:  Nutah [ 27 Mar 2019 13:30 ]
Post subject:  Re: Frame covers
:yup:
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/