| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| isolator bolt fitting https://ukbeg.com/forum/viewtopic.php?f=7&t=24379 |
Page 1 of 1 |
| Author: | ogri211 [ 11 May 2020 09:34 ] |
| Post subject: | isolator bolt fitting |
Im going to be upgrading my isolators shortly, so I am going to be rechecking my swingarm bearing as I fitted a new swingarm a few weeks ago, a couple of questions, firstly setting the tension of the taper rollers, in the book it said to use a ballance scale, is this the best way to do it or is there another way? Also when I took the 5/8" bolts out they looked as if they had studlock on them, I would normally only use studlock on something that never has to come out, so what should I use, dry, copperslip, nutlock or studlock, thanks in advance. |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|