I have received my bar end mirror but realised that I don't have a bar end to attach it to, can only find pairs on the net. Anyone got a spare laying around ... ?!

_________________
"With square conduct, level steps, and upright intentions ..”

Or, if it is not fabricateable from a piece of ally bar, post a pic of what you have so we can see what is missing.

I may have somethig kicking around that may help.

_________________
08 Specialized Langster

Will give it a measure tomorrow in daylight!!

Cheers Nick

_________________
"With square conduct, level steps, and upright intentions ..”

..........And then fit it with a Rawlbolt from a hardware shop

_________________
If your dreams don't scare you, they are not big enough.

I have actually found one! Its an old Rizoma one left over from my Tuber, its got no bolt with it so I guess a rawbolt will do, how do you stop the bar end moving up and down on the end once the rawbolt is in place, I imagine bolting it hard against the bar will stop the throttle turning (no comments!)

_________________
"With square conduct, level steps, and upright intentions ..”

It should have a shoulder that fits up inside the bar. The throttle tube shouldn't foul the bar end if it's OD is 7/8".
Copperslip the pinch bolt and lightly nip it up.

_________________
If your dreams don't scare you, they are not big enough.

Sounds straight forward, just have to cut away the hole at the end of the grip (traction grip)

_________________
"With square conduct, level steps, and upright intentions ..”

So, I have given it a go but it wont work. The end of the handlebar is recessed inside the end of the grip. I have cut away the disk in the end but the grip is quite a bit longer than the end of the handlebar, as such the bar end when done up doesn't allow the throttle to twist. I backed it out a bit and tightened the screw but it just flaps about.

What's more returning from work today I undid my one remaining mirror so I could push the bike down the alley and that snapped too, now I don't have any mirrors at all

Pics attached

_________________
"With square conduct, level steps, and upright intentions ..”

And how is this not technical ... ?

_________________
"With square conduct, level steps, and upright intentions ..”

....you are joking, right ?

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

Its using tools to fit something with technical questions, not just chatting about Buells ... and I don't appreciate you moving my post without at least showing the courtesy of sending a PM first asking me to do it myself.

_________________
"With square conduct, level steps, and upright intentions ..”

It's bar end mirrors mate .......but fuck it, put it wherever you like.

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

And I require detailed answers to a problem that I have, might be piss easy shit for you and mundane but for me who isn't the font of all knowledge, its a big deal

_________________
"With square conduct, level steps, and upright intentions ..”

Smacks of double standards mate.......I move loads of posts like yours every day

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

You have PM, Oh ... and double standards are par for the course around here sometimes!

Now, ... can anyone actually help me on this ?

_________________
"With square conduct, level steps, and upright intentions ..”