The brake caliper will be fine, but you will probably need a new brake line as it will be too short / tight. Good time to fit a new braided one.
Before you fit it, drill a 3mm hole in the underside of the shock pivot fork to let the water out.
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| X1 swing arm bits for S1 https://ukbeg.com/forum/viewtopic.php?f=7&t=5410 |
Page 1 of 1 |
| Author: | TOPGUMM [ 09 Mar 2010 18:31 ] |
| Post subject: | X1 swing arm bits for S1 |
Hi, I will getting rid of the S1 swing arm and fitting an X1 and would like to know what parts I need to source. I have the cast swing arm and belt adjusters . I suppose I need an X1 axle and new bearings and new type isolators (anyone have the part numbers for the isolators) . Do the rear brakes swap over from the S1? or is it worth upgrading . Searched the archives so have some info, thanks. |
|
| Author: | Maz [ 09 Mar 2010 18:47 ] |
| Post subject: | Re: X1 swing arm bits for S1 |
Isolators are L0504.9 and l0505.9.....11.33 each incl. vat. |
|
| Author: | mojomick [ 09 Mar 2010 21:10 ] |
| Post subject: | Re: X1 swing arm bits for S1 |
The brake caliper will be fine, but you will probably need a new brake line as it will be too short / tight. Good time to fit a new braided one. Before you fit it, drill a 3mm hole in the underside of the shock pivot fork to let the water out.
|
|
| Author: | TOPGUMM [ 09 Mar 2010 21:32 ] |
| Post subject: | Re: X1 swing arm bits for S1 |
Got it thanks. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|