Try a magnet first, if that fails it's a wheel out job. Grease the drive before reassembly, whole job half an hour tops. I'll race you Saturday morning (I am doing mine) again.
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Fitting new speedo cable https://ukbeg.com/forum/viewtopic.php?f=7&t=8343 |
Page 1 of 1 |
| Author: | restone [ 09 Sep 2010 20:34 ] |
| Post subject: | Fitting new speedo cable |
My old speedo cable (on S1WL) has snapped at the front wheel end the last 15mm of the square inner is stuck inside the drive unit and I cant get it out. Do I have to take out the front wheel in order to remove the drive unit and tap it out of the drive unit or is there an easier way, I have tried the little grub screw to no avail, Any ideas cheers Rich |
|
| Author: | richie [ 10 Sep 2010 09:56 ] |
| Post subject: | Re: Fitting new speedo cable |
Try a magnet first, if that fails it's a wheel out job. Grease the drive before reassembly, whole job half an hour tops. I'll race you Saturday morning (I am doing mine) again.
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|