UK Buell Enthusiasts Group
https://ukbeg.com/forum/

Help required in Essex (ish)
https://ukbeg.com/forum/viewtopic.php?f=7&t=8383		 Page 1 of 1
Author:  Goldwinger [ 13 Sep 2010 13:46 ]
Post subject:  Help required in Essex (ish)
Hi again all. I'm in need of a kind soul to help with my XB. I'm getting the usual "popping" and jerky throttle response. I don't know where to start with ECM spy, sooooooooooooo what I need is someone who can set my bike up for me?
I've no idea just how easy/complicated the process is , so any advice would be welcome.
Bike is a 09 XB12XT Ulysses, 2300 miles, std exhaust, breather mod done.
Author:  Nutah [ 13 Sep 2010 17:34 ]
Post subject:  Re: Help required in Essex (ish)
08 and later Buells
The 08 and later have a completely different procedure and doesn’t need ECMSpy.

Turn the ignition on, engine kill switch to run, twist the throttle 3 times - keep the throttle fully open for one second and fully closed for one second.

Job done!

from Pash's how to section :worthy: :worthy:

here ....> viewtopic.php?f=17&t=13
Author:  Goldwinger [ 14 Sep 2010 08:07 ]
Post subject:  Re: Help required in Essex (ish)
Thank you Sir, I shall try that as soon as it stops raining.
Author:  Goldwinger [ 16 Sep 2010 06:01 ]
Post subject:  Re: Help required in Essex (ish)
Gotta be honest, I thought you were pulling my chain (I suppose stretching my belt is more appropriate) but it worked a treat!!! Thanks again Nutah and Pash.
She's running much sweeter now.
Whilst cleaning her after a ride I've found one of the exhaust straps has come off and the dreaded (but expected) rust has appeared at a seam, so it's time for a new one under warranty.
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/