well thought i would fit my rear pulley today , for 1/2 US gearing
but after stripping the back end down the pulley i have has
a smaller internal dia. about 3mm so will have to get it machined
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| X1 milarky https://ukbeg.com/forum/viewtopic.php?f=7&t=9909 |
Page 1 of 1 |
| Author: | Nutah [ 12 Feb 2011 21:55 ] |
| Post subject: | X1 milarky |
well thought i would fit my rear pulley today , for 1/2 US gearing but after stripping the back end down the pulley i have has a smaller internal dia. about 3mm so will have to get it machined
|
|
| Author: | pash [ 12 Feb 2011 21:59 ] |
| Post subject: | Re: X1 milarky |
Willybuell can help... |
|
| Author: | Nutah [ 12 Feb 2011 22:00 ] |
| Post subject: | Re: X1 milarky |
so can Jesus , but i aint phoning either of em 
|
|
| Author: | pash [ 12 Feb 2011 22:08 ] |
| Post subject: | Re: X1 milarky |
I have passed your number on to both. BTW, you wouldn't have had this problem with an XB |
|
| Author: | Nutah [ 12 Feb 2011 22:12 ] |
| Post subject: | Re: X1 milarky |
no but i would have had many more Nick 
|
|
| Author: | pash [ 12 Feb 2011 22:31 ] |
| Post subject: | Re: X1 milarky |
|
|
| Author: | pash [ 13 Feb 2011 09:33 ] |
| Post subject: | Re: X1 milarky |
Not enough throw Ian, even with a gap bed. |
|
| Author: | pash [ 13 Feb 2011 09:43 ] |
| Post subject: | Re: X1 milarky |
Funny you should post a piccy of a Colchester, cos that particular model (no gap bed as far as I can see) doesnt have enough throw either ... |
|
| Author: | mojomick [ 13 Feb 2011 10:18 ] |
| Post subject: | Re: X1 milarky |
"The World Turns on Colchester Lathes."  You can do pretty much anything bike related with a "Student" that has a removable gap. 
|
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|