Having been out playing on the X1 all weekend I decided it needed a bath. So I washed it for the first time since I've owned it and lo and behold the front mounting on the exhaust was snapped through on both sides. As I have, up to now, had little interst in tubers I haven't read all the posts but I seem to recall that this isn't unusual. The next question is what to do about it?

An observant MoT tester is likely to fail the bike so I shall need to do something in the next 12 months. The exhaust is a Wileyco and although not prefect it isn't dead either. Besides it sounds quite nice.

So, if I do nothing for the moment am I likely to have any severe problems?

If I have it repaired is the weld likely to last any better a second time?

If I replace it what is a reasonable option which will let me MoT the bike without too much effort?

_________________
Be seeing you

I

pics please

I'll have to send them to you direct, when I've taken them.

Would you PM me you e-mither address.

_________________
Be seeing you

I

does it use the late type front exhaust hanger as ythis goes a long way to helping any make of exhaust last longer,

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Yup!

_________________
Be seeing you

I