viewtopic.php?f=17&t=13
try this mate , a link to Pash's TPS reset it explains it nicely
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| firebolt wont run proper https://ukbeg.com/forum/viewtopic.php?f=8&t=11446 |
Page 1 of 1 |
| Author: | stevemoate [ 26 Jun 2011 11:06 ] |
| Post subject: | firebolt wont run proper |
my XB9R is not well at all. it starts ok and intermittently runs ok, but more often than not, misfires, goes off a cylinder, wont rev up at all and generally runs like a bag of shite! will it be the ecu? any ideas? |
|
| Author: | pash [ 26 Jun 2011 11:13 ] |
| Post subject: | Re: firebolt wont run proper |
Check your earth to the engine for corrosion (under the airbox there is a bonding strap across the stabiliser bar) and a TPS reset would be a good idea too. ECMs generally work or they don't on individual circuits (or the are just dead). |
|
| Author: | stevemoate [ 26 Jun 2011 12:02 ] |
| Post subject: | Re: firebolt wont run proper |
thanks for the tips pash. The TPS reset, is that something i've got to get done at a buell agents? |
|
| Author: | woz [ 26 Jun 2011 12:27 ] |
| Post subject: | Re: firebolt wont run proper |
Dont forget to check the plug leads. Chaffed leads on XB's are very common but this normally shows itself when riding in damp or rainy conditions, still worth checking |
|
| Author: | Nutah [ 26 Jun 2011 14:54 ] |
| Post subject: | Re: firebolt wont run proper |
viewtopic.php?f=17&t=13 try this mate , a link to Pash's TPS reset it explains it nicely
|
|
| Author: | pash [ 26 Jun 2011 15:01 ] |
| Post subject: | Re: firebolt wont run proper |
Yep, with Woz on that one, the front ignition lead likes to chaff on the the tickover screw... |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|