pash wrote:
Thanks Pash "problem loading page" damn
Does that mean you unticked the box?
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| White cable-xb12? https://ukbeg.com/forum/viewtopic.php?f=8&t=11896 |
Page 1 of 1 |
| Author: | DrBuella [ 06 Aug 2011 10:51 ] |
| Post subject: | White cable-xb12? |
On the diagnostics tab on ECM spy it show "white cable" being enabled. I thought this was just on XB9's? |
|
| Author: | pash [ 06 Aug 2011 10:59 ] |
| Post subject: | Re: White cable-xb12? |
No, it isn't just for 9s... Check this... On my Firebolt I just set all the config byte to zero... |
|
| Author: | DrBuella [ 06 Aug 2011 11:15 ] |
| Post subject: | Re: White cable-xb12? |
pash wrote: Thanks Pash "problem loading page" damn Does that mean you unticked the box?
|
|
| Author: | DrBuella [ 06 Aug 2011 11:23 ] |
| Post subject: | Re: White cable-xb12? |
Ah, found the link to XB9 mod. Thanks again Pash |
|
| Author: | gunter [ 06 Aug 2011 12:09 ] |
| Post subject: | Re: White cable-xb12? |
To switch off the white wire is a must, especially with the older XB9, as it might kill you otherwise. This f*cking noise abatement get's activated when you need engine power most, e.g. overtaking a car in low gear. I can't understand how such a dangerous setup got homologated here, but I'm sure no one ever tried it in real life. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|