UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
total eletrical failure https://ukbeg.com/forum/viewtopic.php?f=8&t=1370 |
Page 1 of 1 |
Author: | barnetboy [ 01 Jul 2009 21:30 ] |
Post subject: | total eletrical failure |
xb, 53 plate, was blowing brake light/ horn fuses , engine managment light on, had a rummage about with wiring ,couldn`t find fault.....low and behold no longer blowing fuse . managment light off . so off i trot round the block....... 3miles later bike dies , stalled ...no power, just likesome pulled the plug. fuses ok any ideas ...........or time for box of matches |
Author: | Nate [ 01 Jul 2009 21:53 ] |
Post subject: | Re: total eletrical failure |
Loom damage by the head stock maybe!?! Do the clock needles play up when this happens? Relays, the ignition one. Does not explain blowing fuses. Hmm, Nate. |
Author: | barnetboy [ 01 Jul 2009 22:52 ] |
Post subject: | Re: total eletrical failure |
clocks frozen at 1000rpm,20mph, no viable damage to loom before or after battery ok , bike stopped like it ran out of electricity , nothing, lights, fan ,ignition nothing |
Author: | Nate [ 02 Jul 2009 16:49 ] |
Post subject: | Re: total eletrical failure |
IIRC they can have a break in the loom shroud up by the head stock, not visable, just wondering if it is the main one to the key! If it was me at this stage I would try to determine with a meter which cables should be live into the key switch and which ones should be live with the key turned to on and tug on the loom around the head stock to see if a change happens. The earth points suffer bad in this area too! If everthing is shutting down it sounds like the fuse box/relay box is unless someone corrects me losing power which I'm sure is fed via the key. HTH Nate. |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |