I haven't been out hardly on the bike, (spare time building chop)
, but 500miles on, still all good! 
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| How to: Reduce the drivebelt tension on a STD tensioner https://ukbeg.com/forum/viewtopic.php?f=8&t=1403 |
Page 1 of 1 |
| Author: | yourguitarhero [ 03 Jul 2009 16:03 ] |
| Post subject: | How to: Reduce the drivebelt tension on a STD tensioner |
Has anyone else performed this modification? From reading the description of the FS tensioner, it allows the tensioner wheel to be pushed back (towards footpegs) when there is increased tension, so providing some more 'slide' seems like a good idea? |
|
| Author: | milkster [ 03 Jul 2009 19:35 ] |
| Post subject: | Re: How to: Reduce the drivebelt tension on a STD tensioner |
Hi if you check Landsend`s guide in the how to section it may save you a few quid... |
|
| Author: | yourguitarhero [ 03 Jul 2009 21:43 ] |
| Post subject: | Re: How to: Reduce the drivebelt tension on a STD tensioner |
That's what I'm talking about. |
|
| Author: | pash [ 04 Jul 2009 07:03 ] |
| Post subject: | Re: How to: Reduce the drivebelt tension on a STD tensioner |
Well, Landsend has done it and if you search previous posts, you will see that Maz used to do it too... |
|
| Author: | Lands End [ 10 Jul 2009 22:55 ] |
| Post subject: | Re: How to: Reduce the drivebelt tension on a STD tensioner |
I haven't been out hardly on the bike, (spare time building chop) , but 500miles on, still all good!
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|