| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Help fitting Renthal bars please https://ukbeg.com/forum/viewtopic.php?f=8&t=14198 |
Page 1 of 1 |
| Author: | jakeblues68 [ 20 Apr 2012 07:28 ] |
| Post subject: | Help fitting Renthal bars please |
Hi, I am trying to fit some Renthal bars to my 55 plate XB9SX, the problem I have is that the throttle cables do not seem to be long enough no matter how I route them. Has anyone got experience of this or can offer some advice? Any assistance appreciated 
|
|
| Author: | Nutah [ 20 Apr 2012 09:13 ] |
| Post subject: | Re: Help fitting Renthal bars please |
which model Renthals are you trying to fit  fitted ultra lows to an XBR with an LSL top yoke |
|
| Author: | Ash [ 20 Apr 2012 09:41 ] |
| Post subject: | Re: Help fitting Renthal bars please |
From memory when I fitted new bars on the STT, I had to snip the cable ties holding all the cables together, then the bars fit .. |
|
| Author: | jakeblues68 [ 20 Apr 2012 23:00 ] |
| Post subject: | Re: Help fitting Renthal bars please |
I've cut all cable ties and released all tension, still no avail. The bars are renthal street bars which seem wider and lower than standard. |
|
| Author: | jakeblues68 [ 21 Apr 2012 07:41 ] |
| Post subject: | Re: Help fitting Renthal bars please |
Bump...... |
|
| Author: | gusm2 [ 21 Apr 2012 08:07 ] |
| Post subject: | Re: Help fitting Renthal bars please |
Take a little bit off each side of the bars 
|
|
| Author: | pash [ 21 Apr 2012 08:13 ] |
| Post subject: | Re: Help fitting Renthal bars please |
 Or put some Uly throttle cables on... |
|
| Author: | Bonzo [ 21 Apr 2012 08:55 ] |
| Post subject: | Re: Help fitting Renthal bars please |
gusm2 wrote: Take a little bit off each side of the bars IIRC it's about 1cm off each end.
|
|
| Author: | jakeblues68 [ 21 Apr 2012 09:18 ] |
| Post subject: | Re: Help fitting Renthal bars please |
pash wrote: :yt: Or put some Uly throttle cables on... Many thanks Pash, that sounds like a plan.....any idea where i can get some? |
|
| Author: | pash [ 21 Apr 2012 09:28 ] |
| Post subject: | Re: Help fitting Renthal bars please |
Call Nobby at Black Bear (mention UKBEG for a discount) Or look for someone breaking a Uly on EBay (can't see anything) Or make your own cables up, buy some bits (inner and outer and ferrules) from Venhill. You would be able to use the cable guides for the throttle assembly again from your current cables. Could even see if anyone has some broken cables you could use so you don't need to butcher yours (the parts you need are the same on any Buell cables from 1999 onwards). |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|