Pirtec supply good switches...local
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| X1 banjo bolt https://ukbeg.com/forum/viewtopic.php?f=8&t=14550 |
Page 1 of 1 |
| Author: | cooter [ 28 May 2012 14:40 ] |
| Post subject: | X1 banjo bolt |
Does anyone know the size of the banjo bolt to fit in the top of the rear master cylinder on an X1? Want to remove the bolt and replace with a integrated switch. I think the bolt is 10mm but it's the thread size I'm struggling with? |
|
| Author: | pash [ 28 May 2012 14:47 ] |
| Post subject: | Re: X1 banjo bolt |
M10 x 1.25 as you have a Nissin. Rule of thumb is all Jap stuff M10 x 1.25, Brembo M10 x 1.0 and PM 3/8 UNF |
|
| Author: | cooter [ 28 May 2012 15:11 ] |
| Post subject: | Re: X1 banjo bolt |
Thank you |
|
| Author: | richie [ 28 May 2012 16:14 ] |
| Post subject: | Re: X1 banjo bolt |
Pirtec supply good switches...local
|
|
| Author: | cooter [ 28 May 2012 21:17 ] |
| Post subject: | Re: X1 banjo bolt |
richie wrote: Pirtec supply good switches...local Thanks Richie |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|