Looks as if the rear brake switch on the bike is faulty. Can I remove the switch from the top of the rear master cylinder without loosing any brake fluid please. Thanks.

No

_________________
08 Specialized Langster

Thanks Pash.
Looks like I therefore need to get the bike over to Tubs at Moorespeed to get it sorted.
Anybody got a rear brake sensors switch to sell please? Or am I on my way to the stealership

A goodridge one will fit, you will need an M10x1.25 thread.

you can get a stainless one
they are cheaper than HD
they don't come with the correct connector
you can cut the old connector off with some tails and solder them to the new switch or buy a connector (I posted about aftermarket matching connectors a while back)

_________________
08 Specialized Langster

Thanks again Pash and to you too Topgumm.
I'll give Tubs a chance to settle in to his new job then give him a shout.

Changed out the banjo switch and remembered to get the two crush washers too. I now know how to bleed brakes. And my rear brake light now works.

I did all that, but the brake light still didn't work. Found out afterwards it was a dodgy connector under the seat

_________________
Wear the fox hat