| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| XB12XP 2009 Clutch Adjustment Cover Screws https://ukbeg.com/forum/viewtopic.php?f=8&t=15690 |
Page 1 of 1 |
| Author: | Joth [ 14 Oct 2012 21:22 ] |
| Post subject: | XB12XP 2009 Clutch Adjustment Cover Screws |
Hi Does any one know the thread type and size of a XB12XP 2009 Clutch Adjustment Cover Bolts, The thread on the primary cover has gone and I need a helicoil kit to repair it. If any one knows the correct helicoil kit and the best place to buy them from the information would be greatly received. Regards Joth |
|
| Author: | pash [ 14 Oct 2012 21:54 ] |
| Post subject: | Re: XB12XP 2009 Clutch Adjustment Cover Screws |
The three screws? 1/4 UNC... Plenty of kits on eBay. Make sure you have helicoils the right length, they are sized in multiples of thread diameter, i.e. 1D, 2D etc. you don't need much torque on these, hand tight with a T27 driver will do it, so 1D will be sufficient. |
|
| Author: | Dunk1976 [ 14 Oct 2012 21:56 ] |
| Post subject: | Re: XB12XP 2009 Clutch Adjustment Cover Screws |
Not the 3 screws thread again :lol: |
|
| Author: | Joth [ 15 Oct 2012 09:46 ] |
| Post subject: | Re: XB12XP 2009 Clutch Adjustment Cover Screws |
Thanks for the info, I have ordered the Helicoil kit. I could not believe it stripped off the primary cover, replaced the leaking seals and gaskets, put it all back together and the very last screw just went round and round.  Ordered the Parts Manual so that should help in future. Regards Joth |
|
| Author: | smithy [ 15 Oct 2012 19:32 ] |
| Post subject: | Re: XB12XP 2009 Clutch Adjustment Cover Screws |
Dunk1976 wrote: Not the 3 screws thread again :lol: 
|
|
| Author: | Joth [ 23 Oct 2012 13:36 ] |
| Post subject: | Re: XB12XP 2009 Clutch Adjustment Cover Screws |
Fixed Thanks Joth |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|