| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| uly no go https://ukbeg.com/forum/viewtopic.php?f=8&t=16195 |
Page 1 of 1 |
| Author: | ratass [ 11 Jan 2013 19:25 ] |
| Post subject: | uly no go |
 ok chaps here go's not started my 06 uly since oct battery been on oximiser,turned the key got all the normal whiers and buzzes as things cycle hit start one big grunt and nothing red lights went out now just got high beam light and no action help jon |
|
| Author: | DaveH [ 11 Jan 2013 19:51 ] |
| Post subject: | Re: uly no go |
Get a voltmeter across the battery and look what its reading when you press the starter. Sounds like you've got a cell down. Had this on the xb12s. Battery would fire the bike when freshly charged but leave it a week it would give exactly the same symptons as yours. If its the origional battery you've not done bad. Mine was goosed after four years. Hope this helps |
|
| Author: | ratass [ 11 Jan 2013 19:57 ] |
| Post subject: | Re: uly no go |
battery new in july only done about 100 miles since then jon will check tomo uly only done 3600 miles from new no power on the start button all i got on the dash is the full beam no power to anything else |
|
| Author: | pash [ 11 Jan 2013 20:05 ] |
| Post subject: | Re: uly no go |
Relay? |
|
| Author: | DrBuella [ 12 Jan 2013 20:46 ] |
| Post subject: | Re: uly no go |
Oxide build up on battery terminals? May not be readily apparent! But then if the main beam works? Bad connection elsewhere or relay as Pash says? |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|