UK Buell Enthusiasts Group
https://ukbeg.com/forum/

This doesn't look right
https://ukbeg.com/forum/viewtopic.php?f=8&t=16741
Page 1 of 1

Author:  Bonzo [ 11 Apr 2013 17:17 ]
Post subject:  This doesn't look right

Attachment:
free spirits.JPG
free spirits.JPG [ 204.56 KiB | Viewed 427 times ]


Putting everything back together after rotating the engine. Is it possible to misalign the engine this much when tightening everything up :?:

Author:  pash [ 11 Apr 2013 17:25 ]
Post subject:  Re: This doesn't look right

Rotate the rear wheel in the forward direction...

How many washers behind the FST?

Author:  Bonzo [ 11 Apr 2013 17:36 ]
Post subject:  Re: This doesn't look right

pash wrote:
Rotate the rear wheel in the forward direction...

How many washers behind the FST?


That made it look a bit better, no overhang on the engine side now, and just 2mm on the outside. I've got 1.5mm washers on the inside of the studs (which I didn't have before, it was slightly rubbing on the exhaust strap). Maybe it'll sort itself out once it's all back together :?: :?:

Attachment:
free spirits.JPG
free spirits.JPG [ 119.44 KiB | Viewed 418 times ]

Author:  Bonzo [ 11 Apr 2013 17:37 ]
Post subject:  Re: This doesn't look right

I'd just like to say that I'd be totally screwed without this website :!: :!: :P

(Maybe I'm a bit paranoid, but it's not like bolting up an old jap UJM, and I never took them to the track afterwards :ill: )

And while I'm on a roll, I hope it wasn't Erik who designed the rear silencer mount so that you have to disconnect the fecking oil line to get it off :!:

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/