All good my end, maybe meet up for a beer again somewhere this year.
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Thread lock https://ukbeg.com/forum/viewtopic.php?f=8&t=18644 |
Page 1 of 1 |
| Author: | mushroom [ 18 Apr 2014 19:02 ] |
| Post subject: | Thread lock |
I have read the book and it says To use Loctite 262 on the nut holding the pinion gear in place. will Pro seal medium lock thread do the same job? Loctite breakaway is 22 nm Pro seal breakaway is 18nm How accurate does this need to be? |
|
| Author: | richie [ 18 Apr 2014 20:04 ] |
| Post subject: | Re: Thread lock |
I am no expert, but when I did mine I sourced a small bottle (this stuff is not cheap) but worth it just for the Pease of mind. After all the time, trouble, and expense of doing the job. If you want Paul I'll post it to you, you don't need much. |
|
| Author: | mushroom [ 18 Apr 2014 20:20 ] |
| Post subject: | Re: Thread lock |
Hi Richie, thanks for the offer but I will buy some, I will have it for next time then. I was intending to do the job this weekend, can't find any Loctite locally but can get the Pro Seal in the morning. Hope all is well wit you. |
|
| Author: | richie [ 18 Apr 2014 20:35 ] |
| Post subject: | Re: Thread lock |
All good my end, maybe meet up for a beer again somewhere this year.
|
|
| Author: | mushroom [ 18 Apr 2014 20:38 ] |
| Post subject: | Re: Thread lock |
Sounds good to me, if I get this bike back together, I might even get a ride in. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|