dclee750 wrote:
Thanks for that ,Ill carry on then , Dave
what year did they change size
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| XB Side stand bolt / Clevis pin https://ukbeg.com/forum/viewtopic.php?f=8&t=19830 |
Page 1 of 1 |
| Author: | dclee750 [ 19 Jan 2015 21:07 ] |
| Post subject: | XB Side stand bolt / Clevis pin |
Hi , I have been told the side stand bolt on XB s is prone to snapping where size reduces to the thread on lower part , Im intending to fit a clevis pin about 12.5 mm or 1/2 inch whichever I can find , this will need drilling out of lower part of side stand ( threaded bit ) , but looks a lot smaller than top of side stand , about 20mm , if I stick a 12.5 mm drill through it will it still be strong enough? , has anyone else done this ? Wanted to upload some pictures as my explanation might not be good ,but Im not clever enough, Thanks Dave |
|
| Author: | Maz [ 19 Jan 2015 21:09 ] |
| Post subject: | Re: XB Side stand bolt / Clevis pin |
I have drilled the standard set up many times to take the later clevis and have had no issues. |
|
| Author: | dclee750 [ 19 Jan 2015 21:11 ] |
| Post subject: | Re: XB Side stand bolt / Clevis pin |
Thanks for that ,Ill carry on then , Dave |
|
| Author: | smithy [ 24 Jan 2015 18:27 ] |
| Post subject: | Re: XB Side stand bolt / Clevis pin |
dclee750 wrote: Thanks for that ,Ill carry on then , Dave what year did they change size
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|