| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Q: 2009 extended trouble codes https://ukbeg.com/forum/viewtopic.php?f=8&t=2067 |
Page 1 of 1 |
| Author: | gunter [ 10 Aug 2009 19:36 ] |
| Post subject: | Q: 2009 extended trouble codes |
Anyone who owns a recent service manaual and could tell me the new trouble codes for DDFI-3 models? These are the errors I'm looking for: XB and 1125: - Starter Relay - Auxiliary Power Relay - Neutral - Clutch - Active Intake Control - Speed Sensor - Idle Air Control 1125 only: - Fan 2 - Crank sensor - MAP sensor - Baro sensor Thanks! |
|
| Author: | Devonbob [ 12 Aug 2009 11:09 ] |
| Post subject: | Re: Q: 2009 extended trouble codes |
Got codes from a 2004 XB12s manual if that helps |
|
| Author: | gunter [ 12 Aug 2009 12:51 ] |
| Post subject: | Re: Q: 2009 extended trouble codes |
Thanks a lot, but the pre-2008 models have installed only DDFI-2 ECM types. |
|
| Author: | Maz [ 12 Aug 2009 13:38 ] |
| Post subject: | Re: Q: 2009 extended trouble codes |
gunter wrote: Anyone who owns a recent service manaual and could tell me the new trouble codes for DDFI-3 models? These are the errors I'm looking for: XB and 1125: - Starter Relay - 46 - Auxiliary Power Relay - 47 - Neutral - 27 - Clutch - 26 - Active Intake Control - 22 - Speed Sensor - 43 - Idle Air Control - 34 1125 only: - Fan 2 - Crank sensor - MAP sensor - Baro sensor Thanks! Not so simple with the 1125 as they have a different system of DTC ie. Starter relay is given a DTC of P0616 and a priority order of 61 for ''circuit low'' and a DTC of P0617, priority 60 for ''circuit high'' Fans are listed as left and right and have DTC of P0691>P0694 for high and low circuits and priority no.s 56>59. Crank sensor has P0337>P0339 and P.O's of 7>9 for low, high and intermittent. MAP is P0107/63 for low/open and P0108/62 for high. Baro is P02228/24 for low and P2229/23 for high. |
|
| Author: | gunter [ 12 Aug 2009 14:28 ] |
| Post subject: | Re: Q: 2009 extended trouble codes |
Thank you very much! I will update the XB codes then and keep the fake codes for the hellicon models, which is still sufficient to make software work. |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|