UK Buell Enthusiasts Group
https://ukbeg.com/forum/

Com error
https://ukbeg.com/forum/viewtopic.php?f=8&t=20773
Page 1 of 1

Author:  Ymale [ 13 Sep 2015 20:12 ]
Post subject:  Com error

I have just removed noid and harness fix on 1125R. When I removed the noid I fitted the resistor so I think that's ok. When I turn key on I get a come error flash up then disappear. Would I be right in thinking that when the harness was fitted that they would have flashed the ECM to take the harness into account and that's what's now throwing up the comms error when I turn the key?.

If this is the case would getting a lead and ecm spy sort this?.

Author:  pash [ 13 Sep 2015 20:21 ]
Post subject:  Re: Com error

Why not reconnect the solenoid and see if that is the issue?

Author:  pash [ 13 Sep 2015 20:23 ]
Post subject:  Re: Com error

This may interest you:

viewtopic.php?f=17&t=5066

Author:  Ymale [ 13 Sep 2015 21:41 ]
Post subject:  Re: Com error

Thanks Pash,

Will go back up to the loft to get it and plug back in and see. When comms error comes up is the problem logged in the ecm so that spy could tell me exactly why it's coming up or have I got the wrong end of the stick... On my car when I plug in vagcom it pulls up the error codes so I know exactly what's wrong and can then clear them.

Author:  pash [ 13 Sep 2015 23:55 ]
Post subject:  Re: Com error

Hmmm, not sure, I would have to check...

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/