Hi All,
I recently purchased an XB12S, delivered a few weeks ago started fine and took it out for a spin.
So i parked it in the garage where it has been since then.
So yesterday i went out to start her up and she wouldnt idle and sounded like it was running on 1 cylinder.
i read a lot about a tps reset so off i went and connected up ecmspy and clicked on reset tps.
Now it wont start at all...
any ideas anyone?

maybe i screwed it click the TPS reset but i didnt push any other buttons.

Cheers

john

pash's flow chart for a TPS reset, found in the howto section: viewtopic.php?p=349#p349
If you are using the later ecmspy, then instructions can be found here: http://ecmspy.com/ug_mono/V2.0/liveandl ... #tps-reset

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett

Thanks Gunter,
mine is an 09 model so really i shouldnt of connected the ecmspy and also i have the wrong version right?
the version i have does not look like the "mono' one from the second link and is labelled v1.12.1
thanks
john

If you have a later model which does not require some software for a tps reset, then I would try another reset according to the user's manual. Maybe this will fix the problem.

_________________
"It is often said that before you die your life passes before your eyes. It is in fact true. It's called living."
Terry Pratchett

New set of plugs and leads and now all good
must remember to let it get to temp to stop the plugs fowling!

Want a HRC Carbon front mudguard for your CBR?

_________________
08 Specialized Langster

If not, Restone may be interested in it for his race bike

_________________
If your dreams don't scare you, they are not big enough.