From my understanding of the system, bugger all oil gets there hence the Nipple!
Bash it in and be done.
| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Maz Nipple Mod https://ukbeg.com/forum/viewtopic.php?f=8&t=21223 |
Page 1 of 1 |
| Author: | lotusjez [ 03 Mar 2016 20:46 ] |
| Post subject: | Maz Nipple Mod |
So As I undestand it, it just taps in very gently until flush. An interfearence fit. Will it leak oil without a gasket/seal/hermetite? Jez |
|
| Author: | WILLYBUELL [ 03 Mar 2016 20:58 ] |
| Post subject: | Re: Maz Nipple Mod |
no |
|
| Author: | marcus_asparagus [ 04 Mar 2016 08:18 ] |
| Post subject: | Re: Maz Nipple Mod |
From my understanding of the system, bugger all oil gets there hence the Nipple! Bash it in and be done.
|
|
| Author: | DaveH [ 04 Mar 2016 10:23 ] |
| Post subject: | Re: Maz Nipple Mod |
marcus_asparagus wrote: From my understanding of the system, bugger all oil gets there hence the Nipple! Bash it in and be done. Tsk. You welsh rough boys  .When you remove the rubber seal from the output shaft you'll see an inner shaft sat inside the end of the outer needle roller and hopefully grease will be present. These two shafts both rotate but at different speeds. The inner needle that you can't see stops any transmission oil reaching the outer bearing, as the bike leans to the left on the side stand it will never find its way there during storage. Once the grease dries up that outer needle roller will turn to dust causing a complete engine strip and a bill for about 2 grand. TAP the ally lube plug in carefully. Once its started use a suitable sized socket, only tap in until flush with the end of the output shaft. Do not recess it...........Dave |
|
| Author: | rik [ 04 Mar 2016 10:51 ] |
| Post subject: | Re: Maz Nipple Mod |
DaveH wrote: When you remove the rubber seal from the output shaft you'll see an inner shaft sat inside the end of the outer needle roller and hopefully grease will be present. These two shafts both rotate but at different speeds. The inner needle that you can't see stops any transmission oil reaching the outer bearing, as the bike leans to the left on the side stand it will never find its way there during storage. Once the grease dries up that outer needle roller will turn to dust causing a complete engine strip and a bill for about 2 grand. TAP the ally lube plug in carefully. Once its started use a suitable sized socket, only tap in until flush with the end of the output shaft. Do not recess it...........Dave Not on a tuber  
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|