| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| engine light https://ukbeg.com/forum/viewtopic.php?f=8&t=222 |
Page 1 of 1 |
| Author: | boldy [ 10 May 2009 00:30 ] |
| Post subject: | engine light |
i remember someone else having this problem red eng light appears and bike seem to die for a second but then goes back out and everthing seems fine shes done it twice now and ive had her on ecm spy and no trouble codes earth cables ok i think maybee ignition relay as the bike wouldnt start after stopping for 5 minutes so i turned the ignition off then on again and she started up. never happened before she done 7000mls 06 xb12 any one else had this or similar 
|
|
| Author: | Nate [ 10 May 2009 10:55 ] |
| Post subject: | Re: engine light |
My money is on relays! Had a similar thing happen on mine. They ain't much from Maz. Nate. |
|
| Author: | Kev [ 10 May 2009 19:09 ] |
| Post subject: | Re: engine light |
Where are you? I can offer to read the fault with the laptop if there is one stored. Unless you want to go through the manual read out. |
|
| Author: | Maz [ 10 May 2009 19:16 ] |
| Post subject: | Re: engine light |
Quote: ive had her on ecm spy and no trouble codes
|
|
| Author: | Kev [ 10 May 2009 20:19 ] |
| Post subject: | Re: engine light |
Ah, ta Maz, my signature living up to its name then 
|
|
| Author: | boldy [ 10 May 2009 21:23 ] |
| Post subject: | Re: engine light |
thanks for the help guys i think maybee i go for another relay and see how it goes 
|
|
| Author: | gunter [ 11 May 2009 08:41 ] |
| Post subject: | Re: engine light |
I'm not sure, but I think the only situation the CEL is lit (blinking?) and no code is stored occurs when the engine is overheated and the ECM goes into spark skipping mode. ETS might be the culprit then. If this appears predictably, running a log will be helpfull as the sensor data could be watched how the ECM gets them. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|