UK Buell Enthusiasts Group
https://ukbeg.com/forum/

intake seals
https://ukbeg.com/forum/viewtopic.php?f=8&t=22445		 Page 1 of 1
Author:  dingbat [ 25 Jun 2017 18:33 ]
Post subject:  intake seals
Right so go for a spin and when i pull up revs stay at 2000rpm then after a few second or so drop down to just over a 1000rpm , but it does not do it all the time mostly but not all , posted on Book face page and was told classic intake seal leaks, done a bit of looking and stipped air box and scoops off and sprayed with carb cleaner and .....nothing revs dont rise
is this a definitive test or could it be something other ? apart from revs thingy bikes running fine :headbang:
Author:  pash [ 25 Jun 2017 20:09 ]
Post subject:  Re: intake seals
What is your AFV?

When did it start happening?
Author:  dingbat [ 25 Jun 2017 21:21 ]
Post subject:  Re: intake seals
hi Pash to be honest i tried a race ecm a couple of weeks ago run the bike round the block (it ran crap)and ran out of petrol , pushed it home changed back original ecm , and its been like it since then
havnt checked AFV yet this can be done with ecm spy ?
Author:  pash [ 25 Jun 2017 21:28 ]
Post subject:  Re: intake seals
Yes, with ease. The Race ECM probably needed a TPS reset to make it run properly.
Author:  dingbat [ 26 Jun 2017 21:36 ]
Post subject:  Re: intake seals
hi again Pash finally found my ECM Spy disc got it all up and running again
the Afv is showing 100% tps is 6.0deg and 7.1% if thats of any help
Author:  pash [ 27 Jun 2017 07:22 ]
Post subject:  Re: intake seals
As long as the AFV is not locked to 100% that would suggest your intake seals are not a problem.
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/