| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| XB9r Voltage regulator update 77 connector https://ukbeg.com/forum/viewtopic.php?f=8&t=22762 |
Page 1 of 1 |
| Author: | Bob [ 06 Nov 2017 15:03 ] |
| Post subject: | XB9r Voltage regulator update 77 connector |
Hi Guys, I'm replacing the voltage regulator and and updating connector #77 on my 2004 XB9r. On the old connector the 2 black wires (from regulator) were labeled A & B. After connector (loom side) we have a red and a black. My worry is that the replacement regulator has an upgraded connector fitted and is labelled 1 & 2. Does it matter which of the 2 black wires (new regulator) goes to the black or red of my bike? Or does 'A' ='1' and 'B' = '2' Any input greatly appreciated. Bob |
|
| Author: | Nutah [ 06 Nov 2017 17:24 ] |
| Post subject: | Re: XB9r Voltage regulator update 77 connector |
|
|
|
| Author: | Bob [ 06 Nov 2017 18:45 ] |
| Post subject: | Re: XB9r Voltage regulator update 77 connector |
Nutah wrote: Thanks for quick reply. On my replacement regulator, the three stator wires are ok as they are connected to plug. The 2 remaining wires (battery positive and earth) have a new/upgraded type of plug '77' which I have to fit to loom. All wires from regulator are black and at connector '77' (loom side) they turn red and black. My question is: As I have to fit a new plug, how can I tell which black wire to connect to red?  Thanks |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|