UK Buell Enthusiasts Group
https://ukbeg.com/forum/

Rotor Mod Hole Info
https://ukbeg.com/forum/viewtopic.php?f=8&t=23239		 Page 1 of 1
Author:  TheAlchemist [ 27 Jun 2018 00:01 ]
Post subject:  Rotor Mod Hole Info
Hi,

Is there a technical drawing of the rotor mod with the dimensions needed to carry out the machining?

Many thanks,

Andy
Author:  DaveH [ 27 Jun 2018 08:31 ]
Post subject:  Re: Rotor Mod Hole Info
Give Maz a bell at the emporium after 11.30am. He's got the info you need
Author:  TheAlchemist [ 27 Jun 2018 20:56 ]
Post subject:  Re: Rotor Mod Hole Info
Sorry new to the Buell gathering....

Who is Maz?

Andy
Author:  Nutah [ 27 Jun 2018 22:19 ]
Post subject:  Re: Rotor Mod Hole Info
The independent Buell specialist.. :maz:

viewtopic.php?f=7&t=18897 :here:
Author:  TheAlchemist [ 28 Jun 2018 13:03 ]
Post subject:  Re: Rotor Mod Hole Info
Had a chat with Maz, really knowledgeable chap, thanks for your advice Maz.

After getting my initial bollocking for not having done my homework I have now been set on a straight and narrow path!

There is someone that does the drilling (spark eroding) of the oilway hole down south of the UK somewhere.......do you know the company that does this work?.....Maz cannot remember and the person he used to have this work done does not do it anymore.

Any info would be good so I can follow it up.

Andy
Author:  Maz [ 28 Jun 2018 13:58 ]
Post subject:  Re: Rotor Mod Hole Info
viewtopic.php?f=8&t=22920

page 3
Author:  ursus americanus [ 28 Jun 2018 22:41 ]
Post subject:  Re: Rotor Mod Hole Info
Paul Sadler at Demeanour Customs for engineering your rotor 07981 251711

Steve
Author:  TheAlchemist [ 29 Jun 2018 10:06 ]
Post subject:  Re: Rotor Mod Hole Info
Thank you,

Yes, sent Paul an email last night and had a reply this morning. £100+P&P+VAT, turnaround in a week.
He has asked for the front bearing to be removed before it is sent in. Looking into this now.

Andy
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/