Hi folks,
Further to the switch set I'm in the process of making some case sliders.
These are made of soft alloy so will be destroyed if you slide as they stop your casing being destroyed instead.
I've got a set in mine and I dropped one onto my garage concrete floor whilst trying to fit it & got a dink in it, so these will mark easily, but that's exactly what they should do as they are not for show, although look a damn sight better than standard in my eyes..
I've got the clutch side made (see pic) & in the process of making the stator side which will look the same.
Anyone wants them, £20 to club funds & I'll send them free as a further donation.
The stator side should be made by Friday as I'm off over to see my father in law today.
If there is demand I will make further sets, but they take a day to make one side including hacksawing the blank from a 50mm bar as I'm a lazy F****r.
These are also incredibly fiddly to fit with the seal as anyone who has had their standard one off will know, so persevere & be careful not to drop one like I did.
All the best Paul.
| Attachments: |
|
Case slider 4.jpg [ 571.76 KiB | Viewed 1272 times ] |
|
Case slider 0.jpg [ 368.82 KiB | Viewed 1272 times ] |