UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
S1 front wheel removal. https://ukbeg.com/forum/viewtopic.php?f=8&t=23914 |
Page 1 of 1 |
Author: | Lars [ 07 Jul 2019 16:57 ] |
Post subject: | S1 front wheel removal. |
Decided to give the bike a pair of new tyres, problem, front wheel removal, manual says to remove pads from front calliper to allow clearance. I cannot get the " centre calliper bolt" out easily and I would prefer to work on it later removed. Question is can I remove the disc bobbins to gain sufficient clearance instead? Thanks. |
Author: | Nutah [ 07 Jul 2019 19:47 ] |
Post subject: | Re: S1 front wheel removal. |
https://www.ebay.co.uk/itm/BUELL-X1-LIG ... 100623.m-1 do you mean this bit ? I had one seized in the caliper on my X1 ,i used a dremmell with a small cutting disc , to cut the centre portion of the pin out (but leave enough to get a grip on it in the middle part ) so i could then remove the pads , then remove the caliper to free out the rest of the pin. |
Author: | Maz [ 07 Jul 2019 19:59 ] |
Post subject: | Re: S1 front wheel removal. |
No Don, it's a 97 with the shit PM caliper. |
Author: | Nutah [ 07 Jul 2019 20:00 ] |
Post subject: | Re: S1 front wheel removal. |
![]() ![]() |
Author: | Maz [ 07 Jul 2019 20:02 ] |
Post subject: | Re: S1 front wheel removal. |
.....and by the sound of it, undoing bobbins means it also has a shit brake disc ! |
Author: | DaveH [ 07 Jul 2019 20:39 ] |
Post subject: | Re: S1 front wheel removal. |
Do what nutah says. Though locate a new pin first. Then remove the pads wheel/disc and then drown the bastard in DW40 and remove the offending item. |
Author: | Maz [ 07 Jul 2019 20:44 ] |
Post subject: | Re: S1 front wheel removal. |
![]() ![]() |
Author: | Lars [ 07 Jul 2019 20:52 ] |
Post subject: | Re: S1 front wheel removal. |
Did just that, WD40 and patience, all undone now, no damage, must be one of the good shit callipers? |
Author: | Nutah [ 07 Jul 2019 21:08 ] |
Post subject: | Re: S1 front wheel removal. |
![]() |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |