| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| Jet size for Mikuni Carb https://ukbeg.com/forum/viewtopic.php?f=8&t=24221 |
Page 1 of 1 |
| Author: | ogri211 [ 26 Jan 2020 09:59 ] | ||
| Post subject: | Jet size for Mikuni Carb | ||
I have just received My carb easy kit from the USA, my question is will I need to change the jet size on it or is it set up for the Buell S1, I have a large K and N freeflow filter and a straight through exhaust if this would make any difference. Thanks in advance.
|
|||
| Author: | Finmows [ 26 Jan 2020 11:00 ] |
| Post subject: | Re: Jet size for Mikuni Carb |
FWIW...when I bought my Mikuni, it went straight out the box...straight on the bike...no problems! No rejetting...no fucking about  (That was running a K&N filter and V&H can as well) |
|
| Author: | ogri211 [ 26 Jan 2020 11:56 ] |
| Post subject: | Re: Jet size for Mikuni Carb |
Thanks for that sound as if it will be no problem. 
|
|
| Author: | gusm2 [ 26 Jan 2020 13:28 ] |
| Post subject: | Re: Jet size for Mikuni Carb |
Finmows wrote: FWIW...when I bought my Mikuni, it went straight out the box...straight on the bike...no problems! No rejetting...no fucking about (That was running a K&N filter and V&H can as well)  
|
|
| Author: | Adam [ 26 Jan 2020 13:51 ] |
| Post subject: | Re: Jet size for Mikuni Carb |
Mine went straight on too. However, plug chops (done properly, pref with leaded fuel) are advisable as each bike is different. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|