| UK Buell Enthusiasts Group https://ukbeg.com/forum/ |
|
| XB head conversion inlet flanges. https://ukbeg.com/forum/viewtopic.php?f=8&t=24230 |
Page 1 of 1 |
| Author: | Dancingbuell [ 31 Jan 2020 08:53 ] |
| Post subject: | XB head conversion inlet flanges. |
Good Morning, I am putting an XB12 Top end on my S1W and using my S1W Thunderstorm heads on my Old M2. My question is about my Inlet situation on the XB12 heads, can I use Sporster EFI Inlet flanges and then my normal inlet manifold for my 42mm Mikuni, its a 2010 XB motor. Many thanks in advance. |
|
| Author: | pash [ 27 Mar 2020 10:32 ] |
| Post subject: | Re: XB head conversion inlet flanges. |
No, the bolt spacing changed in 2007. You will need the later flanges 27327-07 |
|
| Author: | 03 [ 27 Mar 2020 11:08 ] |
| Post subject: | Re: XB head conversion inlet flanges. |
OP, presumably a 97/98 M2 then. Bear in mind you need to transplant the Thunderstorm pistons along with the heads into the M2. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|